Aether Posted January 10, 2023 Share Posted January 10, 2023 Hello fellow builders! I have decided to start a squad leader shoretrooper build that will be 3D printed in PETG using Mr. Pauls files. The soft parts I have on order with Darkside Closet. I am currently in the process of printing everything which will take some time as I only have one printer right now. My first question to the group is in regards to the torso section, I am able to flex the printed section enough to get it on and off but am slightly concerned that this make break over time. I plastic welded the pieces together so the seams should be pretty strong and secure. Any thoughts? Picture below for reference. 1 Quote Link to comment Share on other sites More sharing options...
BikerScout007 Posted January 10, 2023 Share Posted January 10, 2023 It depends on a few things. What filament did you use, how many walls and what % infill? I printed my daughter's Mr. Paul kit in PETG with 2 walls and 10% infill and it's surprisingly pretty flexible. And she hasn't manage to break it yet! But if you do 4 walls, 20% and PLA -- might be a bit stiffer. You may want to reinforce the inside of it with fiberglass to keep it from breaking, but that will add to weight and overall stiffness. @MrPoopie -- any advice? 2 Quote Link to comment Share on other sites More sharing options...
Aether Posted January 10, 2023 Author Share Posted January 10, 2023 So I printed mine in PETG with 4 walls at 20% infill so it is pretty much is solid. I've flexed it a few times and taken it on and off about 10 times to start testing it and so far so good. 1 Quote Link to comment Share on other sites More sharing options...
MrPoopie Posted January 10, 2023 Share Posted January 10, 2023 As @BikerScout007mentioned infill percentage, pattern type and number of walls will all have an impact on flexibility and strength. Check out the link below for more detailed info about the subject. That being said you can run a strip (2-3") of fiberglass cloth around the top and another around the bottom edge for extra strength and security in case you develop a crack. That would also keep the extra weight down since you would have less fiberglass and not the entire interior. https://3dprinterly.com/what-is-the-best-infill-pattern-for-3d-printing/ 2 2 Quote Link to comment Share on other sites More sharing options...
KOtrooper Posted January 11, 2023 Share Posted January 11, 2023 Fiberglass will help. On high impact areas on other kits of mine, I glued (with contact cement) nylon webbing in the back for extra strength. 2 1 Quote Link to comment Share on other sites More sharing options...
MikeRadness Posted January 20, 2023 Share Posted January 20, 2023 I printed my Mr. Paul's files with 3 walls, 10% infill in PETG. I also chemical welded my sections along with some epoxy reinforcement along those same seams. Pretty flexible. I did run additional fiberglass reinforcement on the belt tabs, just to be sure. However, I step into my torso like putting on a pair of pants. so that alleviates the need for extreme spreading to slip around my waist. 2 Quote Link to comment Share on other sites More sharing options...
Aether Posted August 15, 2023 Author Share Posted August 15, 2023 Any thoughts on the best place to order the neoprene for the chest/back armor? I was looking around on Amazon for some options but thought I'd check here before I order something. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.