KOtrooper's Biker Scout build

[KOtrooper]

Last bit done before I apply for Lancer. 3D print from@mrpoopie files. Sized up at 112% to better fit my holster. Hopefully flat black is ok for the paint.

Sent from my Pixel 5a using Tapatalk

[Chopper]

Flat black is fine.

[DontDissTheFett]

That blaster came out great! I’d like to slice it up the same way you did because it looks like you had a really clean print and I am not a fan of supports either. Any suggestions Thst you can share of any best practices to do it and situate them?


Sent from my iPhone using Tapatalk

[KOtrooper]

Thanks. I also like to avoid supports. Here are some photos of how I sliced the body. It was all able to print without any supports.

Sent from my Pixel 5a using Tapatalk

[MrPoopie]

32 minutes ago, KOtrooper said:

Last bit done before I apply for Lancer. 3D print from@mrpoopie files. Sized up at 112% to better fit my holster. Hopefully flat black is ok for the paint.

Sent from my Pixel 5a using Tapatalk
 

That's a great finish you were able to get on the blaster. Man do I hate sanding parts.

[DontDissTheFett]

Thanks. I also like to avoid supports. Here are some photos of how I sliced the body. It was all able to print without any supports.

Sent from my Pixel 5a using Tapatalk

That’s great, thank you! Did you split the scope in half by any chance too?


Sent from my iPhone using Tapatalk

[KOtrooper]

35 minutes ago, DontDissTheFett said:

That’s great, thank you! Did you split the scope in half by any chance too?


Sent from my iPhone using Tapatalk

Oh yeah, I cut the scope in half where it gets covered up by another bracket.

[KOtrooper]

Documenting what the 3D print looks like, scaled at 112% for SC holster.

Sent from my Pixel 5a using Tapatalk