clockworksoldier Posted October 7, 2019 Share Posted October 7, 2019 Hey Scouts, What size magnet do I need and where can I find it, for a holdout blaster/leg holster setup? Sent from my iPhone using Tapatalk Quote Link to comment Share on other sites More sharing options...
Chopper Posted October 8, 2019 Share Posted October 8, 2019 Are you using the DVH pistol? I glued these on the back side of my holster: https://www.kjmagnetics.com/proddetail.asp?prod=D83 You can always stack two of them as well, to get more pull. Quote Link to comment Share on other sites More sharing options...
clockworksoldier Posted October 8, 2019 Author Share Posted October 8, 2019 I have a 3D printed pistol by vendetta arms. It already has a half inch recess in the grip Sent from my iPhone using Tapatalk Quote Link to comment Share on other sites More sharing options...
Chopper Posted October 8, 2019 Share Posted October 8, 2019 Ahhh ok, well that changes things a bit. With the DVH pistol, he puts the magnets into the rubber, so you only need to worry about the attachment points on the holster. If you look at the website I linked, https://www.kjmagnetics.com/products.asp?cat=1 you should be able to measure the recessed parts of the blaster and find a compatible magnet diameter that fits. Looking at my DVH blaster, the circular bit on the grip should extend out about 1/8", so you should be able to figure out the total based on how deep the recess is. 1 Quote Link to comment Share on other sites More sharing options...
clockworksoldier Posted October 8, 2019 Author Share Posted October 8, 2019 THANKS AGAIN CHOPPER!!!Sent from my iPhone using Tapatalk Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.