E-22 Blaster Build - 3DpropsNL - First Time Build

[OBXRogue]

This will be the first build of this kind for me. I am pleased with this kit and I am currently researching screws and the process of assembling this kind of kit. If any of you have any favorite products or methods it would be great to be given a nudge in the right direction.

[jyjellyfish77]

Interested to see how this turns out. You won't be able to add many photos through the forum so try to use a hosting site like photobucket to host your photos and then post the link on here. Good luck!!

[OBXRogue]

Photobucket has been a pain. I have not been able to upload images once I log in to photobucket. Are there other site options you might recommend?

  On 12/12/2016 at 6:15 PM, jyjellyfish77 said:

Interested to see how this turns out. You won't be able to add many photos through the forum so try to use a hosting site like photobucket to host your photos and then post the link on here. Good luck!!

[Chiro]

Imgur, its a lot better!

[Racermouse]

Just ordered this one as well, so please be kind and share your progress.

[Obey Wann]

It should be straightforward. I also did a 3D printed one. I added wooden dowels inside the barrels to give it heft and add structural stability. Then I glued it with CA and accelerant. I was done in a night.

[Chiro]

  On 12/28/2016 at 5:20 PM, Obey Wann said:

It should be straightforward. I also did a 3D printed one. I added wooden dowels inside the barrels to give it heft and add structural stability. Then I glued it with CA and accelerant. I was done in a night.

 

You can also use a metal curtain rod or something similar. Less likely to break than wood

[the dirty trooper]

It looks great. I have ordered from these too.