Darth Voorhees Posted October 19, 2011 Share Posted October 19, 2011 Ok..im probably gonna feel dumb when i get the answer for this...but is there any special way to install these? or is it just cut a square hole in the visor half and drill a hole in the helmet and connect em? Quote Link to comment Share on other sites More sharing options...
TB-4813 Posted October 20, 2011 Share Posted October 20, 2011 This is what I followed for mine, looking at the post from TB-7076. I had to do a little dremel action in order to make the bolts fit. http://forum.bikersc...ts&fromsearch=1 Quote Link to comment Share on other sites More sharing options...
Darth Voorhees Posted October 20, 2011 Author Share Posted October 20, 2011 Thanks Geoff! thats what i figured..gonna get that done tonight! All i need now is to get in touch with MonCal for that snout piece. Quote Link to comment Share on other sites More sharing options...
TB-4813 Posted October 20, 2011 Share Posted October 20, 2011 Just be careful not to grind it too thin. I just did that and now I have to get the putty out and strengthen it up a bit. Quote Link to comment Share on other sites More sharing options...
Dart Posted October 20, 2011 Share Posted October 20, 2011 What you said in your first post was dead on. Just using the plastic bolts works fine. I've never had any major issue with my KS. Occasionally, I think to tighten them up but that's about it. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.