LocoOttomobile Posted June 11 Share Posted June 11 When building an E-22 for level 2 certification, the CRL states that the, "Base is based on S&T Airsoft sterling with closed working parts." Does that mean I need to start with an airsoft gun like this one: S&T Full Metal Custom Sterling Airsoft AEG SMG with Heat Sink and Scope, Airsoft Guns, Airsoft Electric Rifles - Evike.com Airsoft Superstore Or does it mean I can use a 3D print as long as its based on the airsoft model like this one: E-22 Blaster (850armorworks.com) thanks! Quote Link to comment Share on other sites More sharing options...
BikerScout007 Posted June 11 Share Posted June 11 It just means that it needs to be based on the Airsoft sterling and not the actual sterling. So a 3D print that is modeled off the airsoft Sterling would be acceptable for L2. 1 Quote Link to comment Share on other sites More sharing options...
LocoOttomobile Posted October 27 Author Share Posted October 27 Ok, so I have the E-22 kit from 850 armor works waiting to be assembled on my work bench. Questions: 1) There are 9 lights: 2 on each side of the rear power tube. Do those need a clear red cover or are the slots open with each LED visible? 2 lights forward of the power tube where the single power tube goes to a double barrel. Any good pictures? 3 lights in counter 1 or two lights in the barrel tips? Are the lights required for level 1 or just level 2? Are 3d printed scope and flashlight ok for level 2 or just level 1? All the fasteners are either button or countersunk M4 screws (just like on paintball guns). However my 3d printed kit also has additional smaller screws modelled in several areas. Are those ok or should I grind them off and drill them for real ones of approximately the same size? Quote Link to comment Share on other sites More sharing options...
BikerScout007 Posted October 28 Share Posted October 28 7 minutes ago, LocoOttomobile said: Ok, so I have the E-22 kit from 850 armor works waiting to be assembled on my work bench. Questions: 1) There are 9 lights: 2 on each side of the rear power tube. Do those need a clear red cover or are the slots open with each LED visible? 2 lights forward of the power tube where the single power tube goes to a double barrel. Any good pictures? 3 lights in counter 1 or two lights in the barrel tips? Are the lights required for level 1 or just level 2? Are 3d printed scope and flashlight ok for level 2 or just level 1? All the fasteners are either button or countersunk M4 screws (just like on paintball guns). However my 3d printed kit also has additional smaller screws modelled in several areas. Are those ok or should I grind them off and drill them for real ones of approximately the same size? The lights aren't required for either Level 1 or 2. They are only optional. The lights were only featured on a few hero troopers. Most did not have them on their E-22s. I just used M4 screws on mine when i assembled it after 3D printing it, but there are also some small "screws" on it that were modeled after the airsoft Sterling. Which ones in particular do you mean? You can always go off the image on the CRL! 1 Quote Link to comment Share on other sites More sharing options...
LocoOttomobile Posted November 12 Author Share Posted November 12 On 8/12/2024 at 7:45 AM, Scripty said: Old thread, but what was the turnaround time on the Keep Trooping trousers? About 5-6 weeks. They come from Asia but the quality was very good. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.