WTF Holster made Easy

[TK-42775]

So was working on this last night, and I noticed the little notch on the inside of the edge of the Holster.

So instead of cutting the outer piece to fit I just made a slot to slide the excess in to. 

A little bit of sanding and trimming, Here's the back side shot. (Yes, the blaster is held magnetically)

 

Add a little E6000

Add Blaster and a little bit of heat gun Work 

[Gree23]

So was working on this last night, and I noticed the little notch on the inside of the edge of the Holster.

So instead of cutting the outer piece to fit I just made a slot to slide the excess in to. 

A little bit of sanding and trimming, Here's the back side shot. (Yes, the blaster is held magnetically)
 
Add a little E6000



Add Blaster and a little bit of heat gun Work 

I thought this was how it was supposed to be done? How are others doing it

Sent from my SM-G986U using Tapatalk

[TK-42775]

If you watch several of the Videos they trim it to slide up against it 

[BikerScout007]

Yeah I mean - that's how it's supposed to be done with any of the armors.  I cover that in this video too:

 

[TK-42775]

Ok watched the video several times and it "looks" like yours is trimmed to sit in the slot rather than cutting the slot out to slide the outer piece in to. Now that I go back and watch carefully I can see where your sliding it in to the slot. and then pushing it in 45:22 - 45-25

Ugg the Cut piece was at 13:30, Completely missed it

 

 

[TK-42775]

BOOTS DONE!