Jump to content

Recommended Posts

Posted

So was working on this last night, and I noticed the little notch on the inside of the edge of the Holster.

QlYyxP4.jpg

So instead of cutting the outer piece to fit I just made a slot to slide the excess in to. 

UPd35qn.jpg

A little bit of sanding and trimming, Here's the back side shot. (Yes, the blaster is held magnetically)

N9IZicK.jpg 

Add a little E6000

moHVckG.jpg

HX521MG.jpg

jPwttgV.jpg

Add Blaster and a little bit of heat gun Work 

nzdN2AR.jpg

  • Like 2
Posted
So was working on this last night, and I noticed the little notch on the inside of the edge of the Holster.
QlYyxP4.jpg
So instead of cutting the outer piece to fit I just made a slot to slide the excess in to. 
UPd35qn.jpg
A little bit of sanding and trimming, Here's the back side shot. (Yes, the blaster is held magnetically)
N9IZicK.jpg 
Add a little E6000
moHVckG.jpg
HX521MG.jpg
jPwttgV.jpg
Add Blaster and a little bit of heat gun Work 
nzdN2AR.jpg
I thought this was how it was supposed to be done? How are others doing it

Sent from my SM-G986U using Tapatalk

Posted

Yeah I mean - that's how it's supposed to be done with any of the armors.  I cover that in this video too:

 

  • Like 1
Posted

Ok watched the video several times and it "looks" like yours is trimmed to sit in the slot rather than cutting the slot out to slide the outer piece in to. Now that I go back and watch carefully I can see where your sliding it in to the slot. and then pushing it in 45:22 - 45-25

Ugg the Cut piece was at 13:30, Completely missed it

 

 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...