L0CKSTER Posted May 23, 2023 Share Posted May 23, 2023 Hey gang, I recently bought and printed this scout helmet from Galactic Armoury and was wondering if someone was able to tell me if it’d pass approvals? https://imgur.com/gallery/gkLCTMp I printed it before joining the 501st so I didn’t realise that certain shapes and indents weren’t allowed. It does have the decals imprinted into the PLA but I can always fill them with putty during the sanding process, that’s if this helmet is ok. (Uploaded pics through Imgur as the photo sizes were too large, hope this is ok) Thanks guys, Cheers from Australia, Lachy Quote Link to comment Share on other sites More sharing options...
Chopper Posted May 23, 2023 Share Posted May 23, 2023 The trapezoids on the upper rear of the helmet will need to get filled in. Also the indents above the eyeslot and below the eyeslot will need to get filled in as well. Those are meant to be decals, not indented details. 😁 From the photos you've posted, the rest of the helmet seems ok. Once properly finished. Quote Link to comment Share on other sites More sharing options...
L0CKSTER Posted May 23, 2023 Author Share Posted May 23, 2023 Haha yeah that’s what immediately worried me once I started reading the CRL 😂 But great, that’s an easy fix. I was also concerned with thickness, or lack there of, of the outer walls of the ear curves/sections. One, for accuracy, and two, for how sketchy it’ll be when trying to run a hot knife through the plastic inside to make the ear holes. I’d hate for it to melt through and ruin the print 🥲 Do you think the ears look ok? Not too thin walled? Quote Link to comment Share on other sites More sharing options...
Chopper Posted May 23, 2023 Share Posted May 23, 2023 Ah, that was not clear in the photos you posted. The angle is funny, but I can't see a big issue with the thickness of the ear for basic. There's no ear hole at all though? It's just flat? If so, then yes, that's going to be an issue and you'll need to carefully cut and sand the ear holes out of the print. Quote Link to comment Share on other sites More sharing options...
L0CKSTER Posted May 23, 2023 Author Share Posted May 23, 2023 Oh sorry yeah my bad, it wasn’t the greatest angle! But no there is the beginning of an ear hole, but it comes to an end about an inch in. I would just have to remove that “wall” that’s inside the canal to make it a continuous hole. Hoping I’ll have a deft hand when it comes to that 😂 1 Quote Link to comment Share on other sites More sharing options...
L0CKSTER Posted May 24, 2023 Author Share Posted May 24, 2023 @Chopper out of curiosity, which vendor did you go through for your approved helmet? Sent from my iPhone using Tapatalk Quote Link to comment Share on other sites More sharing options...
Chopper Posted May 24, 2023 Share Posted May 24, 2023 My helmet is from Strider. Not many were made, though I have an RS on the shelf as well. There are a number of options if you're looking for a helmet. You can peruse some of the makers in this thread: Quote Link to comment Share on other sites More sharing options...
L0CKSTER Posted May 25, 2023 Author Share Posted May 25, 2023 Great! This is really helpful thanks mateSent from my iPhone using Tapatalk 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.