TK90262 Posted January 9, 2022 Posted January 9, 2022 I have a WTF kit. I am getting ready to start the tank build. I am looking for what some of you did to get the trim right for it to fit on the back armor.
Chopper Posted January 9, 2022 Posted January 9, 2022 ROTJ or Mando Scout? I can't recall exactly how the WTF tank is shaped in relation to the back armor, but you'll need to rough trim the tank down enough that it's close to fitting, then make small cuts until you can get it to fit more flush. There's no real magic technique to it, aside from going slowly and working carefully. Note that on the ROTJ scout, the back tank wasn't perfectly trimmed and wobbled around quite a bit, as it was only held on with an elastic loop. These photos should give you a good idea of what to shoot for.
TK90262 Posted January 9, 2022 Author Posted January 9, 2022 It's a shadow scout. I'm just going for basic approval. The trimming part that hugs along the bottom of the back piece is the critical part it seems. To get that contour look. I guess it would be similar to the ROTJ look
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now