MQ's ROTJ Biker Scout WIP

[Roguemama3]

Here's what I have so far, a printed & bondo helmet!  

This weekend I'll finish sanding the heck out of it & hopefully paint it. 

 

 

[Chopper]

Hi Michelle. Nice to see your progress on the helmet. Since you mentioned you're going for Legion approval, one thing to note with regard to some of the 3D printed scout helmet models is that the upper snout hole and any holes on the back trapezoids should be filled in.

From the CRL: "Helmet details created with decals on the originals may not be substituted with actual cutouts, i.e. above the snout area or the trapezoids in the back. If these areas are cut out on the helmet, they must be filled and covered with a decal"

We're here to help you get approved and look your best, so please let us know if we can help, or if you have any questions!

[Roguemama3]

On 2/23/2021 at 6:40 PM, Chopper said:

Hi Michelle. Nice to see your progress on the helmet. Since you mentioned you're going for Legion approval, one thing to note with regard to some of the 3D printed scout helmet models is that the upper snout hole and any holes on the back trapezoids should be filled in.

From the CRL: "Helmet details created with decals on the originals may not be substituted with actual cutouts, i.e. above the snout area or the trapezoids in the back. If these areas are cut out on the helmet, they must be filled and covered with a decal"

We're here to help you get approved and look your best, so please let us know if we can help, or if you have any questions!

Thanks so much!!  I didn't realize they had to be decals, thankfully I'm still in the prime/sanding stage. lol 

All I have left to 3d print is my belt, tank, thermal detonator & gun holster.