Crl question

[Giro118]

Hey all so looking at the crl it says you need a neck seal but the model isn't wearing one. I was wondering if anyone had a screen shot of one of the scouts wearing it? Thanks 

[BikerScout007]

He is wearing one, you just can't see it because of the mandarin collar on the flight suit.

This is from the show:

[Rikitan648]

Trying to figure out what paint were used to weather the kit 

 

[BikerScout007]

6 minutes ago, Rikitan648 said:

Trying to figure out what paint were used to weather the kit 

 

From the CRL:

https://databank.501st.com/databank/File:Weathering_info_graphic.jpg

[Giro118]

13 minutes ago, Rikitan648 said:

Trying to figure out what paint were used to weather the kit 

 

I just used brown paint from an airbrush 

[Rikitan648]

just wondering could i use a chef kit or do i have to a walts kit jw

 

[Chopper]

6 minutes ago, Rikitan648 said:

just wondering could i use a chef kit or do i have to a walts kit jw

 

A specific kit maker is not required for approval in the Mandalorian Scout. You can absolutely use a Chef kit if you'd like.

[Giro118]

47 minutes ago, Rikitan648 said:

just wondering could i use a chef kit or do i have to a walts kit jw

 

Mine is entirely 3d printed 

[takabon]

Are only 1⁄8 inch rivets acceptable for holster mounting? I don't see any problem with binding screws.

 

[BikerScout007]

7 hours ago, takabon said:

Are only 1⁄8 inch rivets acceptable for holster mounting? I don't see any problem with binding screws.

 

Looks like you've made a good case for adding Chicago screws to the Mandalorian Scout CRL.  

[BikerScout007]

10 hours ago, takabon said:

Are only 1⁄8 inch rivets acceptable for holster mounting? I don't see any problem with binding screws.

 

 

I put in for the CRL change.  Should go through in a few days.  Thanks for bringing our attention to this.

[takabon]

I'm glad I could help you.

[BikerScout007]

3 hours ago, takabon said:

I'm glad I could help you.

Holster Gloss white or semi-gloss. Moderate to heavy desert-brown toned weathering. Attached to the outside of the right boot with 1⁄8 inch rivets or similarly-sized Chicago screws. The blaster pistol fits into the holster. Change is in!