Bicep T bit

[BlizzardScout]

I have t bit’s for my bicep. I’m trying to get everything up to pathfinder and need to find movie accurate bits. Any suggestions on were to buy some. Thanks everyone.

 

 

Sent from my iPhone using Tapatalk

[Stroker]

RS and CFO/Strider have the movie accurate ones. However I don't know if they would sell them just as a stand alone. 

[Retrofire]

RS and CFO/Strider have the movie accurate ones. However I don't know if they would sell them just as a stand alone. 

I though MonCal had a pretty close set as well. Best thing to do is reach out to RS and CFO and see if they can take care of you. Maybe also see if there is an accurate 3D print file floating about somewhere in the Empire you could use?

[Stroker]

1 minute ago, Retrofire said:

 

I though MonCal had a pretty close set as well. Best thing to do is reach out to RS and CFO and see if they can take care of you. Maybe also see if there is an accurate 3D print file floating about somewhere in the Empire you could use?

 

The square part isn't thick enough and it's slightly over sized compared to the RS and CFO\Strider. You can actually take a SC set and put a little work into and have a accurate bit. Pandatrooper did it in his build thread.

[mickeymark34]

Is Studio Creations movie accurate? I know he sells replacement parts. 

[Stroker]

15 minutes ago, mickeymark34 said:

Is Studio Creations movie accurate? I know he sells replacement parts. 

It's close,but it's just as mc just a little smaller. Like I said you can make them as the movie bits by following pandateoopers build thread. Same can be done to the mc's bits.