f3tt4l1f3 Posted January 6, 2020 Posted January 6, 2020 I'm currently working on modding my 3D printed helmet to the screen used helmet images. Looking at the rear "indents" in this image, the 8th one (closest to the center of the back) appears to be a bit wider than the other 7. I did a quick look through the scout scenes in ROTJ but could never find one that had the larger, 8th, "indent" like the above image. However, I did see a few that had a 9th "indent" that was really thin (almost nonexistent). My main question is, if I mod my "indent" pattern to match the above image, will I have to take it back to the 8 uniform "indents" if I decide to try for lancer level later on?
BikerScout007 Posted January 6, 2020 Posted January 6, 2020 We've never held it against anyone that has either 7 or 8 indents in the back. I'm wondering if the 9th one you saw is actually the seam in the helmet where it was assembled in two halves. 3
f3tt4l1f3 Posted January 7, 2020 Author Posted January 7, 2020 The thin (9th) "indent" could very well be due to the seam. It appears that since the seam runs through that area, they weren't very consistent on how they filled it in. This image is a screen-cap of the scout that tried to capture Leia. There's a very thin, faint line. Most likely due to the seam. 2
Chopper Posted January 7, 2020 Posted January 7, 2020 That's definitely a mould seam line. Nice attention to detail in your research though.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now