DJ's Biker Build Questions

[DJMoore]

Hi All, 

So I am working on my Biker Scout build. I am hoping to go for Lancer so I am trying to build to those specs. Thanks to these forums my Husband and I have been able to answer many questions. Yet I have come to 2 questions I have not been able to find answer for. Attached is a picture of the tank topper greeble for reference. 

 

Question A: Does the rivet need to line up with the long fine? Specs says it's to be center of the Greeble but that would make is slightly off center on mine. And to line up with the long fin would mean I need to remove one of the shorter fins leaving 7. 

 

Question B: The white circle located on the bigger circle, can it be painted or does it need to be drilled out to show the tank through the hole?

 

Thanks for the help,

DJ

[Stroker]

You have the rivet placemat correct. 

The circle needs to be painted.

[DJMoore]

3 minutes ago, Stroker said:

You have the rivet placemat correct. 

The circle needs to be painted.

Thank you!!!! I know for level 1 the circle had to be painted but was not sure for Lancer thank you very very much!

[Stroker]

1 minute ago, DJMoore said:

Thank you!!!! I know for level 1 the circle had to be painted but was not sure for Lancer thank you very very much!

No problem! Also when you go to add the white circle make sure it's about the same size as the button that goes on the tank topper. 

[DJMoore]

2 minutes ago, Stroker said:

No problem! Also when you go to add the white circle make sure it's about the same size as the button that goes on the tank topper. 

Got it, was planning on using the button to draw the circle when I went to paint it Good to know I was right on track.