redbird96 Posted March 22, 2019 Share Posted March 22, 2019 I can't seem to find any details on actually building the belt (maybe I'm not looking in the right places). How is the plastic attached to the nylon belt? Is it E6000 all around and rivets at the end or are rivets used along the length of the belt? Thanks in advance. Quote Link to comment Share on other sites More sharing options...
spyder918 Posted March 22, 2019 Share Posted March 22, 2019 Hey Eric, Take a look at some of the builds and you'll see how the belt is put together. Here's a great build to take a look at - Quote Link to comment Share on other sites More sharing options...
pvicta Posted March 22, 2019 Share Posted March 22, 2019 My belt was part of my kit from SCThe instructions were to use rivets to attach to the nylonWhat it didn't say, but I was advised to do, is to use scrap abs (in my case from a TK) as a washer to stop it pulling back throughBut as suggested, see what others have done, and try to match to your buildSent from my SM-G950F using Tapatalk Quote Link to comment Share on other sites More sharing options...
BikerScout007 Posted March 22, 2019 Share Posted March 22, 2019 32 minutes ago, redbird96 said: I can't seem to find any details on actually building the belt (maybe I'm not looking in the right places). How is the plastic attached to the nylon belt? Is it E6000 all around and rivets at the end or are rivets used along the length of the belt? Thanks in advance. The nylon webbing is attached to belt ends with one silver rivet on each side. 2 Quote Link to comment Share on other sites More sharing options...
Chopper Posted March 23, 2019 Share Posted March 23, 2019 My belt has the rivet attachment, as required by the CRL. However, because the single rivet can become a stress point, I put a piece of plastic between the webbing and the rivet backing plate. I also ran my webbing a bit further into the plastic portion of the belt, and secured it with velcro. 1 Quote Link to comment Share on other sites More sharing options...
Aliaz Posted March 23, 2019 Share Posted March 23, 2019 My belt has the rivet attachment, as required by the CRL. However, because the single rivet can become a stress point, I put a piece of plastic between the webbing and the rivet backing plate. I also ran my webbing a bit further into the plastic portion of the belt, and secured it with velcro. Same here!Skickat från min iPhone med Tapatalk Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.