Thermal Detonator question

[redbird96]

I haven't seen many place dictating the length of the hose to use for the TD. The one I do remember seeing, though I don't remember where, said that the hose was 300 cm (or 1 foot). This is the length I used but it just LOOKS short to me. Is what I have here acceptable?

[BikerScout007]

It looks short because your TD housing is really big.   Here is a screen used one (the greeblies have long since fallen off of it)

 

Yours also is symmetrical, whereas the originals are wider on one side than the other.  That's because the long greeblie goes on the left side, and the round greeblie goes on the right.

[redbird96]

10 minutes ago, BikerScout007 said:

It looks short because your TD housing is really big.   Here is a screen used one (the greeblies have long since fallen off of it)

 

Yours also is symmetrical, whereas the originals are wider on one side than the other.  That's because the long greeblie goes on the left side, and the round greeblie goes on the right.

So this would not pass for basic approval? Fortunately, I still have about 5 feet of hose left.

[BikerScout007]

You'll be fine for basic.  I definitely wouldn't go for L2 with that though. 

[redbird96]

Ok, thank you

[carlospiloto2002]

Adequate measure detonator tube?