Jump to content

Recommended Posts

Posted

You are doing a fabulous job !!! 

On the feedback front , I've got two comments , first is the half inch elastic on the knees , I think using the pop rivet is a mistake . You will find the half inch elastic stretches and goes out of shape easily , especially if you have it tight enough to do its job ...what I am saying is  that it will need replacing occasionally . Far better to have the pop rivet there for show, and Velcro the half inch elastic in position to make replacement simpler . Just a thought .

Second point is also about pop rivets, a mistake almost everyone makes , the pop rivet on the tank topper goes in from underneath , the bit you can see on the tank topper is the load spreading washer and the end of the pop rivet . The head of the pop rivet is inside the tank . 

Question : how is the magnet holding the blaster ? I also tried that method but it didn't work for me , I ended up fitting a steel trigger gard and glueing a few magnets under my holster lip . It works fine now . 

 

 

 

Posted

So for my magnet I sanded down the circle on the left size of the blast grip a bit and then glued in a circular shaped magnet to that spot. Once it was secure I then set it in the holster and glued the connecting magnet on the inside area of the holster. Using the blaster to hold it in place while it adhered.

5GIcB2Z.jpg

GzrD9Vx.jpg

 

  • Like 1
  • Thanks 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...