ForesterDesign Posted November 10, 2017 Posted November 10, 2017 I don't think it's allowed for Lancer, but my goodness is it pretty. Chose to go with a silver filament for natural "metal" weathering, going to primer it black tonight! Quote
ForesterDesign Posted November 10, 2017 Author Posted November 10, 2017 Whoops - here it is rightside up: https://imgur.com/CC2i0nw Quote
BikerScout007 Posted November 10, 2017 Posted November 10, 2017 Why wouldn't it be good for Lancer? Unless it varies greatly from the movie blaster, you should be fine. EDIT: Of course that drilled barrel and scope would need to be filled in.... Quote
ForesterDesign Posted November 10, 2017 Author Posted November 10, 2017 Why wouldn't it be good for Lancer? Unless it varies greatly from the movie blaster, you should be fine. EDIT: Of course that drilled barrel and scope would need to be filled in.... Haha, exacccctly. I have to make it less functional for a higher status! 1 Quote
Haydeus Posted November 12, 2017 Posted November 12, 2017 One of the nicer 3D printed blisters I've seen. Well done! Quote
Haydeus Posted November 12, 2017 Posted November 12, 2017 Blasters not blisters. Stupid auto correct Quote
Crix Posted May 23, 2018 Posted May 23, 2018 Is this the one from thingiverse? https://www.thingiverse.com/thing:42811 I printed one, but unsure if the size was correct.. feels small, but then I've never held a real one either.. I've only just started research on the biker scout.. so i know nothing .. https://i.imgur.com/KPQ11lE.jpg Quote
762s Posted May 23, 2018 Posted May 23, 2018 I printed one, but unsure if the size was correct.. feels small, but then I've never held a real one either.. I've only just started research on the biker scout.. so i know nothing .. https://i.imgur.com/KPQ11lE.jpg for comparison ... the dvh blaster is about 7 1/2" long and 4 1/2" tall and 2 3/4" wide the pistol grip/trigger guard opening is about 1 1/2" wide and 2 1/2" tall Quote
Crix Posted May 24, 2018 Posted May 24, 2018 for comparison ... the dvh blaster is about 7 1/2" long and 4 1/2" tall and 2 3/4" wide the pistol grip/trigger guard opening is about 1 1/2" wide and 2 1/2" tall thank you!! seems close... Quote
Dragon_a Posted May 25, 2018 Posted May 25, 2018 And the big advantage is that they're much lighter than resin or rubber blasters so it won't pull your boot down nearly as much when its in the holster. Quote
SikSiks Posted May 25, 2018 Posted May 25, 2018 The 3d printed one from thingiverse is slightly smaller than my current hyperfirm. I am going to be printing another at 114% to see if I can match. This is just a press fit photo mostly right off the printer. Quote
Crix Posted May 25, 2018 Posted May 25, 2018 110 https://imgur.com/gallery/jmaKyzt I made this one at 110% 1 Quote
CatfoodRob Posted September 29, 2018 Posted September 29, 2018 I printed mine at 106 percent and it is corrrect size compared to a real singlepoint sight . 1 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.