My 3D Printed Scout Blaster

[ForesterDesign]

I don't think it's allowed for Lancer, but my goodness is it pretty. Chose to go with a silver filament for natural "metal" weathering, going to primer it black tonight!

 

 

 

 

 

[ForesterDesign]

Whoops - here it is rightside up:

 

https://imgur.com/CC2i0nw

[BikerScout007]

Why wouldn't it be good for Lancer? Unless it varies greatly from the movie blaster, you should be fine.

 

EDIT: Of course that drilled barrel and scope would need to be filled in....

[ForesterDesign]

Why wouldn't it be good for Lancer? Unless it varies greatly from the movie blaster, you should be fine.

 

EDIT: Of course that drilled barrel and scope would need to be filled in....

 

Haha, exacccctly. I have to make it less functional for a higher status!

[Haydeus]

One of the nicer 3D printed blisters I've seen. Well done!

[Haydeus]

Blasters not blisters. Stupid auto correct

[Crix]

Is this the one from thingiverse?

https://www.thingiverse.com/thing:42811

 

I printed one, but unsure if the size was correct.. feels small, but then I've never held a real one either.. I've only just started research on the biker scout.. so i know nothing ..

https://i.imgur.com/KPQ11lE.jpg

[762s]

I printed one, but unsure if the size was correct.. feels small, but then I've never held a real one either.. I've only just started research on the biker scout.. so i know nothing ..

https://i.imgur.com/KPQ11lE.jpg

 

for comparison ...

 

the dvh blaster is about 7 1/2" long and 4 1/2" tall and 2 3/4" wide

 

the pistol grip/trigger guard opening is about 1 1/2" wide and 2 1/2" tall

[Crix]

for comparison ...

 

the dvh blaster is about 7 1/2" long and 4 1/2" tall and 2 3/4" wide

 

the pistol grip/trigger guard opening is about 1 1/2" wide and 2 1/2" tall

thank you!!

 

seems close...

 

[Dragon_a]

And the big advantage is that they're much lighter than resin or rubber blasters so it won't pull your boot down nearly as much when its in the holster.

[SikSiks]

The 3d printed one from thingiverse is slightly smaller than my current hyperfirm. I am going to be printing another at 114% to see if I can match. This is just a press fit photo mostly right off the printer.

[Crix]

110 https://imgur.com/gallery/jmaKyzt

 

I made this one at 110%

[CatfoodRob]

I printed mine at 106 percent and it is corrrect size compared to a real singlepoint sight .