AJay Irish Posted September 30, 2017 Posted September 30, 2017 Ok guys, so working with a Studio Creations kit, I am also quite a scrawny guy, so I need to mould the chest piece in at the sides. I’ll upload a pic with this, my question is this: can I trim right back the highlighted lower part to make it a little easier to mould it without buckling it? I really would love to be approved while still being able to do this lol. I need to bring it in about 2cm each side, so it is quite a lot of strain unless I take that edge off.
AJay Irish Posted September 30, 2017 Author Posted September 30, 2017 Sort of solved my problem anyway; am taking a wedge out of the corner 1
Chopper Posted September 30, 2017 Posted September 30, 2017 That may be a better solution, since if you trim too much off the bottom edge you risk stressing the center ridge and cracking it. I assume you're going to use a heat gun to bend the edges?
AJay Irish Posted September 30, 2017 Author Posted September 30, 2017 I’ve heard mixed emotions about the heat gun, I think I’m more partial to the water bath idea.
Chopper Posted September 30, 2017 Posted September 30, 2017 Yeah, that'd work too. Def go with whatever you're most comfortable with.
Eyeslave Posted October 1, 2017 Posted October 1, 2017 Have you tried on the chest piece while wearing the undersuit & vest? I am a skinny guy and had no issue with the SC chest.
AJay Irish Posted October 1, 2017 Author Posted October 1, 2017 Yeah I did try it on, it just sat way too wide on me
Digger Posted October 2, 2017 Posted October 2, 2017 I ordered an SC kit last week and as i am the skinniest guy i know, i may be having the same issue. Your fix seems like a good one. Will you let us know how the bending goes?
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now