TB-1599 Posted May 4, 2017 Share Posted May 4, 2017 Ok so I started the process of upgrading my boots. Before I start to cut into them. I just want to double check my lines. (note the darkened areas is what will be removed) any advise? Quote Link to comment Share on other sites More sharing options...
Stroker Posted May 4, 2017 Share Posted May 4, 2017 Looks good. I would clean the glue up around the dog bone and paint the soles a solid wheat color. I'd make the horizontal groove a bit wider. Again that's me. Quote Link to comment Share on other sites More sharing options...
TB-1599 Posted May 4, 2017 Author Share Posted May 4, 2017 You actually just named everything on my check list LOL. The Horizontal groove actually goes from where the Pen mark is to where the two colors meet. That will actually be the line... Quote Link to comment Share on other sites More sharing options...
TB-1599 Posted May 5, 2017 Author Share Posted May 5, 2017 Started cutting last night. (This is going to be a long process LOL.) Going to take some sanding paper to the grooves to smooth them out when I am done.. Sent from my SM-G950U using Tapatalk Quote Link to comment Share on other sites More sharing options...
Dart Posted May 5, 2017 Share Posted May 5, 2017 So far, so good. I was just gonna say that you don't need to cut really deep. The actual boots were only about 1/16" deep at that point (based off my measurements of Sierra Sneakers IV). Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.