Just want to double check lines before I put blade to boot.(update 4 May 2017 Started cutting)

[TB-1599]

Ok so I started the process of upgrading my boots. Before I start to cut into them. I just want to double check my lines.

(note the darkened areas is what will be removed)

 

 

 

 

 

any advise?

[Stroker]

Looks good. I would clean the glue up around the dog bone and paint the soles a solid wheat color. I'd make the horizontal groove a bit wider. Again that's me.

[TB-1599]

You actually just named everything on my check list LOL. The Horizontal groove actually goes from where the Pen mark is to where the two colors meet. That will actually be the line...

[TB-1599]

Started cutting last night. (This is going to be a long process LOL.)

Going to take some sanding paper to the grooves to smooth them out when I am done..

 

 

 

Sent from my SM-G950U using Tapatalk

[Dart]

So far, so good. I was just gonna say that you don't need to cut really deep. The actual boots were only about 1/16" deep at that point (based off my measurements of Sierra Sneakers IV).