KW designs Helmet Bolts in an SC helmet

[Brew2d2]

Evening Scouts, I'm in need of a little assistance. Im trying to install the correct helmet bolts so that I can apply for Lancer and I was wondering if anyone had visuals and instructions on how to install the KW designs 3M bolts in an SC helmet? Any help would be greatly appreciated!

 

Brew2D2

[Stroker]

Well there's two ways.

 

1 cut the corresponding holes out to accept the bolts.

 

2 you can cut the back side of the bolt off and glue them on.

 

Which I've done both.

[BikerScout007]

Well there's two ways.

 

1 cut the corresponding holes out to accept the bolts.

 

2 you can cut the back side of the bolt off and glue them on.

 

Which I've done both.

 

That about covers it. I used the "glue on" method myself

[Griffin-X]

Same here...

[Brew2d2]

Is either way preferred? Thanks for the info guys! í ½í±í ¼í¿»

[Stroker]

Is either way preferred? Thanks for the info guys! ������������

I'm a welder and deal with the 3m bolts all the time. If I was you I'd just cut the back off and glue them on. Theyre easily broken and tend to wear quick. I go through a set a month during the summer.

[Brew2d2]

 

 

I ended up enlarging the holes and installing them. Thank you all for your inputs. Howd it come out?

 

Brew2D2