Back plate armour mod information

[TK8271 Rogue Trooper]

For your information

 

I would encourage everyone that is building this costume to add these to your back armour , if you have not done so already :thumbsup:

 

1. Blue arrows , small rectangle raises

2. Red arrows, 2 small square holes and 1 small circle hole that can ether go all the way through or backed. When backed the cutouts are not shallow and must be deep enough to match the second below picture. NOTE this picture has been brightened to show the depth and the light grey is darker than shown

3. Green arrow , one long rectangle raise

4. Orange arrow, one circle raise

5. Yellow arrow , cutout recess

6. Black arrow , cutout recess

7. White arrows , 2 recess behind each rear strap housing

 

 

When backed the circle and squares should match the picture which is approx 5mm deep. NOTE this picture has been brightened to show the depth and the light grey is darker than shown.

 

 

close up of 2 x recess slots behind each rear strap housing

 

 

Also some Prop builders have left out the top right hand side circle recess, so this should be added if missing

 

hosting image

 

 

 

[Krom1975]

For your information

 

I would encourage members to make these very easy mods to your armour.

 

1. Blue arrows , small rectangle raises

2. Red arrows, 2 small square holes and 1 small circle hole

3. Green arrow , one long rectangle raise

4. Orange arrow, one circle raise

5. Yellow arrow , cutout recess

6. Black arrow , cutout recess

 

 

Also some Prop builders have left out the top right hand side circle recess, so this should be added if missing

 

this great. Thanks for pointing this stuff out

 

 

Sent from my iPhone using Tapatalk