Measurements for holdout blaster

[codybb]

SO I need measurements for the Holdout blaster.. I have a 3d printed one that I printed out and I am not sure if its scaled to small or I just gotta get used to the tiny little blaster. any info would be helpful I might have to print out another blaster.. would be a good opportunity to print one in ABS plastic.

[Erik R]

I think mine was the same file, and they're really just that small lol

[kayelbe]

Yeah, they're that small. If your SC kit is on-hand, put it in the holster. You'll be able to tell because the top scope knob will sit in a notch.

[Rockhop7]

I have an SC kit and need a new blaster. Not finding a 3d file for this. Where do I look?

[codybb]

here is the one i printed http://www.thingiverse.com/thing:42811 and here is the next one I will print http://www.thingiverse.com/thing:40356

[Shada]

I also printed the first one and used it for my initial troops. Worked ok but I upgraded to a Darth Vorhees after that

 

 

Sent from my iPhone using Tapatalk