Belt specs for Lancer

[TB-17317]

 

Hey guys,

 

I've been following Panda's tutorial and I have a question on what to do for the back part of the box? Trying to find references (10 mins worth of searching) but I can seem to find a good high res pics of that specific spot.

 

If I'm trying to build for Lancer is it ok to rivet that part of the belt?

 

 

Sent from my iPhone using Tapatalk

[kayelbe]

From an approved Lancer (Mr Poopie)'s thread:

 

[TB-17317]

Sweet! Thanks!

 

 

Sent from my iPhone using Tapatalk

[TB-17317]

Oh also, I want to round off the corners. That's OK right?

 

 

Sent from my iPhone using Tapatalk

[Retrofire]

There should be a rivet on either side to connect the nylon webbing to the back of the belt. For the Lancer spec those should be the only two rivets on the belt. Make sure you size the belt length wearing your bund and flight suit. You might also want to add E6000 to the inside edge before you rivet to give it extra strength. I'm pretty sure I have some belt pics on my thread if you want to take a look. Hope that helps.

[Retrofire]

I didn't round off the corners of my belt Just left them as is.

[BikerScout007]

You can round them off. It will cut down on armor bites

[BlitzJaeger]

You can round them off. It will cut down on armor bites

 

This was the first thing I asked Mickey, those corners are sharp enough to cut trees in half.

[Retrofire]

I know what I'll be doing this weekend with a pair of scissors and some sandpaper.