KS- Wip (current state of affairs)

[shdwtrpr13]

Ok so after a bit of work and taking my time the below is what I have gotten down. I have both areas glued but when I drie fit them together to figure on hole placement I find that their a bit off. about 1/8 to 1/2 of an inch on one side. (I'll post those pics up after my armor party today).

 

 

20131006_121850 by shdwtrpr13, on Flickr

 

20131006_121834 by shdwtrpr13, on Flickr

 

20131006_121822 by shdwtrpr13, on Flickr

 

20131006_121818 by shdwtrpr13, on Flickr

 

I am planning on sand and painting the bucket once I figure out how to line it up properly. any help would be greateful.

[Chex]

You're off to a good start. With the KS, it can be a little wonky in some places. You just have to make it work and look the best you can, and you're doing a good job. Keep it up.

[shdwtrpr13]

Thanks man. All the support I get helps. And any sneaky tips. So far one of the scouts in my garrsion has been quite helpful with small ideas. I just hope I can work on some of them this week.