Bonded Hawk Posted March 7, 2013 Share Posted March 7, 2013 Before I go further do I need to remove more from the visor area? I'm not real good at comparing photos to the face piece in hand. Thanks BH Quote Link to comment Share on other sites More sharing options...
Chef Posted March 7, 2013 Share Posted March 7, 2013 no, that's plenty. Quote Link to comment Share on other sites More sharing options...
Bonded Hawk Posted March 7, 2013 Author Share Posted March 7, 2013 I didnt mean visor. Sorry, working graveyards and was woke up 4 hrs early. I know better . I mean the eye opening in the face piece, not the visor. BH Quote Link to comment Share on other sites More sharing options...
BrewDiver Posted March 8, 2013 Share Posted March 8, 2013 Looking at the face plate it looks like the upper right needs to a little bit higher and slightly sharper with a rounded edge Quote Link to comment Share on other sites More sharing options...
Bonded Hawk Posted March 9, 2013 Author Share Posted March 9, 2013 Had to go out of town but I brought the faceplate to work on. Of course I left all files, sandpaper, and dremmel at home. Quote Link to comment Share on other sites More sharing options...
BrewDiver Posted March 9, 2013 Share Posted March 9, 2013 Snag some 80 and 300 grit from lowes or home depot Quote Link to comment Share on other sites More sharing options...
Bonded Hawk Posted March 9, 2013 Author Share Posted March 9, 2013 Small town. I'll have to go to the lumberyard, bailbond, and taco house. Quote Link to comment Share on other sites More sharing options...
cucblack Posted March 11, 2013 Share Posted March 11, 2013 Need be bigger. Use a dremel tool sand. Be careful... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.