Guest BS1 Posted September 23, 2012 Share Posted September 23, 2012 Has anyone used some type of ribbing in top of boot flap top keep it perfectly round and will that pass lancer??? Quote Link to comment Share on other sites More sharing options...
Pandatrooper Posted September 23, 2012 Share Posted September 23, 2012 The SC kit comes with a curved piece of plastic to mount inside the boot so it stays round. You could also cut the rim and bottom off an ice cream bucket, cut a slit verically in the back and mount that inside the boot too. I intend to do something like that. Quote Link to comment Share on other sites More sharing options...
Guest BS1 Posted September 23, 2012 Share Posted September 23, 2012 Yea gonna come up with something.. I found some boning they use for corssets, thinking of putting that in the top rim of boot before I sew the top over.. what ya think.. Quote Link to comment Share on other sites More sharing options...
4505Marcel Posted September 23, 2012 Share Posted September 23, 2012 I just brought a sheet of abs from the model shop and cut a strip about 20mm wide and heated it a little to give it the curve to match the holster Quote Link to comment Share on other sites More sharing options...
Huntman Posted September 24, 2012 Share Posted September 24, 2012 These are some great Ideas. I was just starting to make a set of boots but lookes like I may hold off for a bit just in case. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.