upper boot flap!!!!!

[Guest BS1]

Has anyone used some type of ribbing in top of boot flap top keep it perfectly round and will that pass lancer???

[Pandatrooper]

The SC kit comes with a curved piece of plastic to mount inside the boot so it stays round.

 

You could also cut the rim and bottom off an ice cream bucket, cut a slit verically in the back and mount that inside the boot too. I intend to do something like that.

[Guest BS1]

Yea gonna come up with something.. I found some boning they use for corssets, thinking of putting that in the top rim of boot before I sew the top over.. what ya think..

[4505Marcel]

I just brought a sheet of abs from the model shop and cut a strip about 20mm wide and heated it a little to give it the curve to match the holster

[Huntman]

These are some great Ideas. I was just starting to make a set of boots but lookes like I may hold off for a bit just in case.