Nahlens

I don't exactly have any spare ABS around, but I did do a test print recently for a backing plate from MrPoopie's files, I think that it should work well enough for the backing plate to attach the engine and aerator

Howdy Pathfinders, My name is Conor, over the past few months I've been slowly putting together an ROTJ Scout as my first costume, and the one that will finally get me into the 501st! I've done a decent amount of research (thanks to this forum) and I believe I've got nearly everything I need, or ordered. Since its a first costume, I went the easy way, getting a used set of armor, and a prebuilt helmet from RS Prop Masters. So far in total I have: Helmet: RS Prop Masters Pro Build Armor: Studio Creations Jumpsuit: Kriptontop Vest: Kriptontop Boots: Used, unsure of make, but they appear to be good enough for the CRL Gloves: Wampa Wear Cummerbund/Cod: Chrisx909x (on order) Pouches: Pilot Bay Balaclava: Under Armor Blaster: Blasterworks (On order) Tried everything on earlier, so here's me looking goofy with no cummerbund on (no balaclava too) I did also get a ukswrath audio system for the helmet since I like the idea of it (despite reading that the speaker is fairly quiet). It's not installed yet as I haven't yet worked out how I want to 3d print the backplate for the engine piece. Any tips would help! Additionally, CRL states that the gloves should not flare, but I couldn't see a decent way to have them not flare. Any tips on that? (I'm aware that's only for Lancer, but it bothers me) Looking forwards to getting this approved and getting out trooping!