TK-42775

BOOTS DONE!

Ok watched the video several times and it "looks" like yours is trimmed to sit in the slot rather than cutting the slot out to slide the outer piece in to. Now that I go back and watch carefully I can see where your sliding it in to the slot. and then pushing it in 45:22 - 45-25 Ugg the Cut piece was at 13:30, Completely missed it

If you watch several of the Videos they trim it to slide up against it

So was working on this last night, and I noticed the little notch on the inside of the edge of the Holster. So instead of cutting the outer piece to fit I just made a slot to slide the excess in to. A little bit of sanding and trimming, Here's the back side shot. (Yes, the blaster is held magnetically) Add a little E6000 Add Blaster and a little bit of heat gun Work