Koenig

It's official I'm TB-11305. Thank you to all those that help with my random questions. Now just have to wait for a chance to get out. Now on the another pathfinder build.

I'll definitely check it out. Was just about all set but forgot to send a picture of my flak vest so got it sent and just waiting now.

So a bit off topic but while I'm waiting I was debating making a set of shadow scout armor to swap back and forth. My issue is gloss black or flat? I see both are allowed but only ever saw gloss.

Thanks still waiting lol. Hopefully it's all good so I can go to the next one.

Well it's all done and submitted now I wait.

Ok cool I was looking at the close-up pictures and didn't think about looking at the belt but thanks. I was going to use paper but was not sure where to start.

Who are you asking? I personally have wampa gloves and got them a few days after ordering but never had anything from I B

Ok so my suede is here and I'm going to start with the butt flap. My issue is in one picture it looked like it's center cheek to center cheek but then the pictures with it being worn it looks wider. Anyone have any information on how to measure this?

I sold a few on forums and eBay. Right now I just have the imperial, sith and a first order logo stand.

Ok guess I got the other ones but I got the ok on them so no big deal now just gotta get cutting and glueing.

I make the stands

Ok so while I wait for my suede to get here I was going to work on my boots but just noticed that my boots have two different color gum soles and the one in the write up is solid. Anyone have issues with sole color?

Ok they are not tight tight but definitely a bit snug in a few spots. And ok I was going to try and wear them in the house a bit but ok was not sure if anyone else has tight boots.

Ok so I got my kingshow boots a week ago in the size I normally wear but they seem a bit tight. Now normally that's fine I'd just break them in quick but if I do that I don't think I'll be able to use them for scouts boots. Was anyone else's boots a bit tight a first?

My Scout is make completely from PLA+. Prints like pla but stronger like abs. I make most of my props from it unless it will be under serious abuse then I switch to something else. That said I know abs can be tricky especially if you don't have an enclosed printer as the heat won't stay even. But short answer yes the right PLA and proper finish work as MrPoopie stated and it can be done.