Rob787

hey Op i also have a SC kit and it looks like this , it look green when you look out but its black on the outside

thanks for the extra eyes , this is before i did the recommended weathering , i will post up the pics of the suggestion thank you . Got my numbers

weathering

started the weathering process ... lesson learned less is more with scout trooper armor , did a first attempt and it was to much so i tone it down and i think they look reasonably weatherd.

test fit , still have to hammer out a few things like the pouch in front my side boxes are not even , cummerbund is drooping a bit and also belt it a bit loose and i might take the padding of my helmet so it will drop a bit more and hide my chin and loosen up the tapered cod so a few adjustment here and there i think.

Thank you for the info guys. so i have a small 3d printer and was able to cut into a few pieces a hold out blaster model and after a good 2 days of printing it came out pretty good now a bit of elbow grease

well almost all the armor is done , still need to attache the pouches to the cummerbund and the boxes to the belt in the back . and currently 3d printing the hold out blaster. and i made a mistake on belt i did 2 rivets instead of 1 arhhggg my question will it not pass the crl for scout tropper? or do i have to have the 1 rivet

so i got the correct bolts from a forum seller , and a bit of sintra and patience boom aligned

The dome was not to bad to put together just made some guidelines an rechecked a few times. I was able to purchase the correct bolts so hopefully with the new bolts and a bit of cintra I can fix the visor.

hello everyone so i decided to start my wip so here it goes armor / helmet is SC already have soft parts will post a pic later , just finished my helmet but have to re work it one of the side did not match up so i have to add some sintra inside and lower a tad to see if it can be flushed. painted black cut out the ear sides and added magnets to hold will update after fix.