blue72beetle

What's this magic chemical that bonds PETG?

I made my own binos the other day. Used the 'Sub Assault' game and some greeblies from an old model car kit. Gave it a bit of weathering too.

So I'm doing new armor from SC, and I'm installing this tank topper. I notice my old one (mon cal I think) doesn't have the hole on the "switch" it has a painted white circle. I see the CRL says "white painted circle". Am I suppose to fill in the big hole with something and then paint it? What have other people been doing with the SC piece? I noticed the SC sticker sheet has a white circle with it.

I just got my correct bolt set in the mail for my helmet. Searching for any sort of instructions, I either can't find anything or the photobucket curse has killed any photos. Can someone post a picture of the correct order these go in, or some sort of instructions?

Well I picked it up today. Lots of the soft parts fit, boots are too small. Now I just need flight suit, gloves, and boots. Still not sure what I'm going to do about the yellowing. The shoulders, chest, and back are the worst.

I'm looking to buy a used set of armor from a local Trooper. They said it's a little yellowed, and they were going to weather it but never did. Sounds like the price would be a lot less than if I bought new armor. They did say the costume was approved, but I don't know if that was before or after yellowing. Can slightly yellowed armor be approved, or am I looking at a lot of work to get it back to white? The armor in question is on the right. It doesn't look bad at all to me, but I'm a noob.