Fraktilfilth

You can use Ethyl Acetate to smooth pla prints. You have to be quite careful as the heat to create the vapour is also enough to start warping smaller parts Sent from my ONEPLUS A3003 using Tapatalk

Yes it's the same for both Sent from my ONEPLUS A3003 using Tapatalk

I went for sculpting the other details out of modelling clay then mounted them to some balsa wood. Sent from my ONEPLUS A3003 using Tapatalk

It is a material called plastazote. Sent from my ONEPLUS A3003 using Tapatalk

Depending which helmet you have its a safe bet that it will be a moulded detail. Some of the first runs of helmets released missed this detail but I believe most have fixed it Sent from my ONEPLUS A3003 using Tapatalk

Yes, it is actually what has been used for the crl photo at the moment. Sent from my ONEPLUS A3003 using Tapatalk

This image from the topps card trader shows how different the armour colour can appear in one shot of the film. It is also quite useful as there are TK's next to them for reference. The shoretrooper at the front is most likely in shadow given how grey the TK next to him is. The shoretrooper behind is probably quite close if maybe a little bit over saturated with light. Sent from my ONEPLUS A3003 using Tapatalk

Ok thank you. The lmo did also make mention that it was spec ops open and transparent nature that helped foster such a great community so quickly, that this was perhaps a leaf that the pathfinders could take from there book. In this respect would you be able to make a thread with the source material that the crl was based, especially if it contains images previously unseen by the building community. Sent from my ONEPLUS A3003 using Tapatalk

Even a rough one would be great to put a lot of peoples mind at rest. Sent from my ONEPLUS A3003 using Tapatalk

Hi was looking for a proposed crl since my build is underway. Need to make sure we are all singing off the same hymn sheet. Sent from my ONEPLUS A3003 using Tapatalk