tuskenfett

Mask off the sides of the snout where it will be straight then take a small peice of card stock or thick paper and bend is so it lines up with the straight sides, it will naturally give a near perfect curve on the top of the snout then tape it on real good and spray away! This is the method I used and it came out perfect

I used a blow dryer to heat up the vinyl then hot glued the reinforcement wire in and check this thread http://forum.bikerscout.net/index.php?show...=2047&st=20 it's the best

I reall Want her to be lancer so I'm trying to get as close to screen as I can

So I tried to bring in the visor just a hair to get that real good scout curve and I think it's just too late I couldn't get anything to hold and everything is already attatched so it's gonna stay like it is

The td will be fixed tonight (you guys were right) Her soft parts are lancer so I had the flak vest made I little wider to fill the space and the slots in the back are fixed I made the Velcro too tight and had to make new ones

The td greebs go both ways. All the lightning bear shots show the circle on the left side where as the troop who chases Han into the endor troops shows it on the right

She's all done! she is all submitted and pending approval

Thanks man! Your the mod king!

Here it is! Thanks for lookin!

Here they are!! And they have the lancer notches in the sole both top and bottom, front and back. Thanks for looking!

pm sent

Test fit

you dont know anything drew

Hit up mc for the decals

I trimmed about an inch off all the way around. Does anyone have a measurement for the rank stripes?