8224

The boots need to be shortened, that will make you look taller. I also recommend to bring the chest a bit up, as far as I can see you have a gap where the shoulders meet. Smaller pouches are needed, I'm sure a larger trooper will be happy to buy yours. Bring the biceps up so that they don't overlap with the forearm. They can be overlapped by the flakvest.

I would have angeled just a bit more down to cover the bottom of the laces.

Sweet!

Mine goes to my nipples. If it's too low your vest will show if you raise your arms. If you have your armour belt, you can measure from your belt to your nipples. The belt should cover the lower edge of the cummerbund.

I think it looks way too shiny. And it's polyester, so you'll be all warm and sweaty in no time.

I have that picture and dosens of the same quality, but nothing shows the details.

I'm working on Aurra Sing, and I'm building her rifle now. I have a pretty accurate 20 inch figure I use for reference when I don't have any good pictures. It looks really screen accurate, so I trust this part to be correctly sculpted by the figure makers. The part I'm looking for is what I think is a biker scout pistol. It looks like they have used the scope one place, and the trigger another place. Scope and trigger: Scope from different angle: Now what is this? Can't remember having seen anything like this before: Hope you guys can help me find the right gun and greebles for this rifle!

Oups, my bad! I didn't see which forum this was in.

That will not look good, sorry. I don't think it will be approved. Stick to thin twill or matte tackle twill, it looks much better!

Good luck! Remember to wear gloves to prevent burns, but do remember that they may leave marks on the warm plastic if you wear them with the "fingerbumps" inside. It's ok to swap the gloves left to right so you don't have the bumps on the inside. Btw, what maker is this?